Poketron

A repairable computer, power bank and communications device built on open hardware.

Design preview

Your kind of computer.

  • Raspberry Pi™ insideZero 2 W, a widely supported compact computer
  • Replaceable & upgradeable components
  • Runs on battery power
  • Versatile LinuxDesktop, server, phone or custom device

Connecting people.

  • 4G mobileWith the optional Radio board
  • Wi-Fi
  • Bluetooth
  • LoRaShort messages across multiple kilometres

Power to you.

  • USB-C power bank
  • Replaceable standard 21700 batteries
  • Two sealed USB-C ports

Built to last.

  • Water & dust protection
  • Fanless
  • Made to be repaired
  • No structural glue
  • 3D-printable parts

Everything you need.And then some.

Carefully specified.

Size
120 × 80 × 31 mm.
Weight
Approximately 400 g including batteries (estimate).
Compute
Raspberry Pi Zero 2 W for Linux applications. A small always-on controller runs the power bank and power-up on its own, so the device works even with the Pi switched off.
Storage
Replaceable microSD card in the Raspberry Pi.
Network
Wi-Fi and Bluetooth LE on the Raspberry Pi and built-in LoRa. 4G LTE with an eSIM, and GPS, on the optional Radio board.
Power
Two replaceable 21700-format cells with protection and a fuel gauge. USB-C charging from 1.5 A or 3 A chargers, and power-bank output to other USB-C devices.
Protection
Designed to resist water and dust, targeting IP67, with sealed screw wells and screwed, gasketed USB-C fittings. Not yet tested.
Radio
Main L4.2 includes LoRa at 868 MHz, up to +22 dBm. The optional Radio R1 board combines 4G, GPS and a receiver designed for 30 MHz to 2 GHz.
Interface
3.7-inch touch e-paper display, front-facing speaker and two microphones with small top vents. Two USB-C cartridges sit midway between the front and back faces. They handle charging and USB accessories or power-bank output. All six ports use the same M13 thread. A 13 mm flathead fits either straight slot. Each side has two buttons with rounded, recessed 6.2 mm press faces. Main L4.2 connects the lower pair. The side ports also fit an optional antenna carrier.
Camera
Front-facing Raspberry Pi camera behind the display window.
Construction
A durable polymer enclosure with an integral rear, top and bottom. Six sealed screw wells are printed in one piece with the cradle for the two cells. Common M3 screws secure the inset front plate for servicing.

Truly yours.

Poketron electronics and enclosures are open hardware. Study, modify, manufacture or sell them under the CERN-OHL-W-2.0 licence.

You’re welcome to modify and distribute the hardware. If you do, please make your modified design source available under the same licence. Sirius Business Ltd is the design and trademark rights holder. Modified products must not be presented as official Poketrons.

Raspberry Pi is a trademark of Raspberry Pi Ltd.

Raspberry Pi board photographs by SparkFun Electronics, adapted for the 3D model under CC BY 2.0.